Technical principle:
Sinton Electromagnetic heater: Electromagnetic heater is a device that uses the principle of electromagnetic induction to convert electrical energy into heat energy. The electromagnetic heating controller rectifiers 220V, 50/60HZ alternating current into direct current, and then converts direct current into high frequency and high voltage electricity with a frequency of 20-40KHZ. Or 380v 50/60HZ three-phase alternating current is converted into direct current and then direct current is converted into 10~30KHZ high frequency low voltage high current electricity, used to heat industrial products.

Sinton Electromagnetic heating ring: high-speed changes of high frequency and high voltage current flowing through the coil will produce high-speed changes in the alternating magnetic field, when the iron container is placed above, the surface of the container is cut alternating magnetic field lines and the metal part at the bottom of the container produces alternating current (eddy current), eddy current makes the carrier at the bottom of the container high-speed irregular movement, carriers collide with each other, friction and generate heat energy. Thus, it has the effect of heating things. It is a heating method that generates induced eddy current on the surface of the heated steel body by converting electrical energy into magnetic energy. This method fundamentally solves the problem of low thermal efficiency caused by the heating of electric heating sheet, electric heating ring and other resistance through heat conduction.

Product electrical specifications:
1, Rated voltage frequency: 380VAC 50Hz /60Hz
2, voltage adaptation range: 310V-450V
3, rated power: according to the workpiece heating requirements
4, working frequency: 8.5-45KHz the best section 12-20KHz, generally 12-13KWHz,
5, safe working environment temperature: -20℃-45℃;
6. Working humidity: ≤95%
7. Thermal efficiency ≥95%
8. Wiring diagram
9. The distance between the coil and the heated body is 20-25MM (the thickness after wrapping).
10, working current: 90KW: 135A / 60KW: 95-100A / 30KW: 45-50A / 15KW: 23-28A.
11, the use of high-speed input and output current hall sensor, can more accurately detect the phase, current size

Basic performance overview:?
1, soft start function, in the case of frequent start, safe and reliable, long service life.
2, there is a lack of phase protection.
3, IGBT overcurrent protection function.
4, input and output overcurrent protection automatic adjustment of negative feedback function. Input protection Output protection 90KW: 135A 90KW: 200A 60KW: 100A 60KW: 130A 30KW: 50A 30KW: 100A 15KW: 28A 15KW: 60A
5, IGBT overtemperature protection function.
6, heating coil short circuit protection function.
7, heating coil open circuit protection function.
8, full bridge series resonant circuit topology, strong anti-interference ability.
9, the use of high-performance IGBT driver chip drive, perfect drive and output waveform.
10, automatic identification of load and phase lock function, so that the load end to get the highest power factor, but also make the circuit precise control in the weak inductive area of high efficiency work.
11. Several electromagnetic heating controllers are installed in parallel on the same heater without interfering with each other.
12, good power saving effect: compared with the current use of electric heating coil, power saving can reach more than 30%.
13, easy to install: can be connected to the bucket type and plate type and other structural induction coil.
14, low operating cost, less maintenance, product warranty for 1 year, lifetime maintenance.
15, according to customer needs through the digital module access digital oil field to the production command center.